>

DESIGN CONCEPT


So as you can see, I literally combined 4 different things in a 1

  1. A humidifier
  2. A sensor
  3. A displayer
  4. A light

  • an internal support

    • So this was the hardest part, I had so many ideas in my head on how would this work in one design
    my Idea was that for the design to work is that I have to combine two different concepts and make them work together,
    In my case was a LANTERN and a HUMIDIFIER and since I had to work with a Ultrasonic mist maker that was kinda heavy, therefore I had to think of water tank that can make it works, since when I tried it, it needed alot of water to make some mist and it needed to be put with an exact water level.
    Problems I faced while doing the design:
    On the instruction:

  • Deep the module in the water keeping 4 to 5 cm water level above the device.
  • Not deep it in water more than 5cm for maximum fog output.
    So I had to put that in mind while designing it!!

    and for the head of the humidifier, I saw that I should make something that can be taken off when it's needed and made sure to have little holes to assure the mist to find its way outside!



  • an external support

    • As I said, I wanted to make a humidifier that looks like a lantern and works like a censer, plus I had no choice but to make it little big since the internal body of the water tank was designed little big for the mist maker!!! In short I was limited in choices


    and with arabic touch
    However for the design of the external body, I made something that can look like a typical traditional lantern with some traditional touch!!!though, in the design I could'nt use the frame to show how it's supposed to be since every time I try to do that, my PC crashes while doing that.



    Like I said, I struggeled a lot with my PC during the designing phase of the external body, since it crashed whenever I tried to use the EXTRUDE, thus I made everything manually when I laser cut it !!


    And the place where I would put the atomiser place with a tube attached to it, which is going to be in water.For it to be more effective, it's better for the atomiser plate to not have a direct contact with water, therefore I filled the tube with cotton to be soaked with water and do it's job to provide the place with enough water to be transformed into mist!


    Files
    interior body of the design
    exterior body of the design