Bordorless Connect Four¶

This is a concept I’ve seen online somewhere (I don’t remember exactly where). I though it would be a cool and quick project to make.

The design¶

The 3D parts can be found and modified following this link.

I’ve made the base in a 18 mm thick teak shelve.

I’ve used some beech stick for the supports.

I’ve 3D printed the yellow and red parts using PLA.

I’ve first Milled the base. The holes are 15mm deep.

I’ve cut each stick about 150mm long.

I’ve printed all the yellow and red parts using PLA. No supports needed.