# Generic AVR Makefile - Adapted for FabTinyStar # Brian Mayton # # 'make' builds the .hex file. # 'make flash' uses the programmer to load it onto the target chip. # 'make fuses' programs the fuse bits on the target chip. # 'make rstdisbl' blows the reset fuse. # 'make clean' removes all autogenerated files. # OBJECTS should list all of the object files for the program (e.g. for each # .c file, list a corresponding .o file here.) APPLICATION just specifies the # name of the hex/elf files, and can be whatever you want. OBJECTS = main.o usbdrv/usbdrv.o usbdrv/oddebug.o usbdrv/usbdrvasm.o APPLICATION = fts_firmware # Set up which MCU you're using, and what programmer, and the clock speed # here. MCU = attiny45 PROGRAMMER ?= stk500v1 F_CPU = 16000000UL port= /dev/ttyS4 # Fuse bit settings EFUSE=0xFF HFUSE=0xDD LFUSE=0xE1 # Fuse bit settings with reset pin disabled HFUSE_RSTDISBL=0x5D # Edit these if you want to use different compilers CC = avr-gcc OBJCOPY = avr-objcopy SIZE = avr-size AVRDUDE = avrdude # Compiler and linker flags CFLAGS=-mmcu=$(MCU) -Wall -DF_CPU=$(F_CPU) -I. -funsigned-char \ -funsigned-bitfields -fpack-struct -fshort-enums -Os -Iusbdrv LDFLAGS=-mmcu=$(MCU) all: $(APPLICATION).hex clean: rm -f usbdrv/*.o rm -f *.hex *.elf *.o %.hex: %.elf $(OBJCOPY) -j .text -j .data -O ihex $< $@ $(APPLICATION).elf: $(OBJECTS) $(CC) $(LDFLAGS) -o $@ $^ $(SIZE) -C --mcu=$(MCU) $@ %.o: %.c $(CC) $(CFLAGS) -c $< -o $@ %.o: %.S $(CC) -x assembler-with-cpp $(CFLAGS) -c $< -o $@ flash: all $(AVRDUDE) -p $(MCU) -c $(PROGRAMMER) -b19200 -P $(port) -e \ -U flash:w:$(APPLICATION).hex fuses: #AVRDUDE = avrdude -c stk500v1 -P /dev/ttyACM0 -b19200 -p $(DEVICE) $(AVRDUDE) -p $(MCU) -c $(PROGRAMMER) -b19200 -P $(port) \ -U lfuse:w:$(LFUSE):m -U hfuse:w:$(HFUSE):m \ -U efuse:w:$(EFUSE):m rstdisbl: $(AVRDUDE) -p $(MCU) -c $(PROGRAMMER) -b19200 -P $(port) \ -U lfuse:w:$(LFUSE):m -U hfuse:w:$(HFUSE_RSTDISBL):m \ -U efuse:w:$(EFUSE):m .PHONY: all clean install fuses