//Darshan Shah, Fab Academy 2018.

#include <SoftwareSerial.h>

// constants won't change. They're used here to set pin numbers:
const int buttonPin = 3;     // the number of the pushbutton pin
const int ledPin =  7;      // the number of the LED pin

// variables will change:
int buttonState = 0;         // variable for reading the pushbutton status
char codetosend = '4';

SoftwareSerial myserial(5,6);
void setup() {
  // initialize the LED pin as an output:
  pinMode(ledPin, OUTPUT);
  // initialize the pushbutton pin as an input:
  pinMode(buttonPin, INPUT_PULLUP);
  myserial.begin(9600);
}

void loop() {
  buttonState = digitalRead(buttonPin);

  // check if the pushbutton is pressed. If it is, the buttonState is HIGH:
  
  if (buttonState == LOW) {
    // turn LED on:
    digitalWrite(ledPin, LOW);
    myserial.write(codetosend);
    delay(100);
  }
  else {
    } 
}