/* Code created by Darshan Shah,
       during Fab Academy 2018. */
                
const int LED_RED = 9; // declaring red led in pin
const int LED_GREEN = 7; // declaring green led pin
const int LED_BLUE = 10; // declaring blue led pin

void setup() {
  // Initializing LED's for the output
  pinMode(LED_RED, OUTPUT);
  pinMode(LED_GREEN, OUTPUT);
  pinMode(LED_BLUE, OUTPUT);
}

void loop() { // analogWrite values from 0 to 255 in this case
  analogWrite(LED_RED, 0); // Red led ON
  delay(100);       // wait for 0.1 seconds     
  analogWrite(LED_RED, 255); // Red led OFF
  analogWrite(LED_GREEN, 0); // Green led ON 
  delay(100);
  analogWrite(LED_GREEN, 255); // Green led OFF 
  analogWrite(LED_BLUE, 0); // Blue led ON 
  delay(100);
  analogWrite(LED_BLUE, 255); // Blue led OFF
}
//starts loop again