//Alzubair Alshehhi 13-June-2018
//FabAcademy 2018

#include <SoftwareSerial.h>

int LED = 7;    // the number of the LED pin
char oncode = '2';

        
SoftwareSerial myserial(0,1);
void setup() {
  // initialize the LED pin as an output:
  pinMode(LED, OUTPUT);
  myserial.begin(9600);
}

void loop() {

if(myserial.available()>0){
  
char inputtext = myserial.read();
  if (inputtext == oncode) {
    // turn LED on:
    myserial.print("Signals Match!");
    digitalWrite(LED, LOW);
    delay(200);
    digitalWrite(LED, HIGH);
    delay(200);
    digitalWrite(LED, LOW);
    delay(200);
    digitalWrite(LED, HIGH);
    delay(200);
    digitalWrite(LED, LOW);
    delay(200);
    digitalWrite(LED, HIGH);
    delay(200);
    digitalWrite(LED, LOW);
    delay(200);
    digitalWrite(LED, HIGH);
    delay(200);
  } else {
    // turn LED off:
    digitalWrite(LED, LOW);
    myserial.print("Signal Is Over. ");
    delay(200);
  }
 }
}