Supply Symbols GND, VCC, 0V, +5V, -5V, etc. Please keep in mind, that these devices are necessary for the automatic wiring of the supply signals. The pin name defined in the symbol is identical to the net which is to be wired automatically. In this library the device names are the same as the pin names of the symbols, therefore the correct signal names appear next to the supply symbols in the schematic. <author>Created by librarian@cadsoft.de</author> >VALUE SUPPLY SYMBOL Mounting Holes and Pads <author>Created by librarian@cadsoft.de</author> MOUNTING HOLE 2.8 mm with drill center MOUNTING HOLE 3.0 mm with drill center 3,0 MOUNTING HOLE 3.3 mm with drill center MOUNTING HOLE 3.6 mm with drill center MOUNTING HOLE 4.1 mm with drill center MOUNTING HOLE 4.5 mm with drill center 4,5 MOUNTING HOLE 5.0 mm with drill center 5,0 MOUNTING HOLE 3.2 mm with drill center MOUNTING HOLE 4.3 mm with drill center MOUNTING HOLE 5.5 mm with drill center >NAME >VALUE MOUNTING HOLE with drill center marker Female Headers etc. Naming: FE = female # contacts - # rows W = angled <author>Created by librarian@cadsoft.de</author> FEMALE HEADER >NAME 1 >VALUE 40 >VALUE >NAME FEMALE HEADER RESISTOR >NAME >VALUE RESISTOR wave soldering >NAME >VALUE >NAME >VALUE 1 >NAME >VALUE >NAME >VALUE LED 1206 pads (standard pattern) >NAME >VALUE LED1206 FAB style (smaller pads to allow trace between) >NAME >VALUE 5mm round through hole part. >NAME >VALUE >NAME PIN HEADER >NAME >VALUE 1 1 >NAME >VALUE >NAME >NAME >NAME >VALUE >NAME >VALUE LED >NAME >VALUE (Black) (Green) >NAME >VALUE MISO SCK RST VCC MOSI GND >NAME >VALUE >Name 1 2 Resistor (US Symbol) Variants with postfix FAB are widened to allow the routing of internal traces SMD slide-switch AYZ0102AGRLC as found in the fablab inventory. Includes the mounting holes. Made by Zaerc. LED 3.5mm terminal block, 2 positions ED555-2DS as found in the fablab inventory. Stolen from <a href="http://www.ladyada.net/library/pcb/eaglelibrary.html">Adafruit</a>, adapted by Zaerc. Supply Symbols GND, VCC, 0V, +5V, -5V, etc. Please keep in mind, that these devices are necessary for the automatic wiring of the supply signals. The pin name defined in the symbol is identical to the net which is to be wired automatically. In this library the device names are the same as the pin names of the symbols, therefore the correct signal names appear next to the supply symbols in the schematic. <author>Created by librarian@cadsoft.de</author> >VALUE SUPPLY SYMBOL RASPI 40 pin GPIO