N.R

Nany Robot

Final Project

Making Smart Robot To Carry My Daughter while my wife is busy with house work

Read more
0

Assignments

This Assigment is About Electronics Production As we Are Going to Start work with Electronics so every one Must Have His Own personal Programer for Micro controller Circuits So I have Searched in the Available Programmers Either David's Or Andy Or Valentin Or Zarec But Really Because i have to Much Work to do this Week i Decided To Work with The hello ISP 44 , After Checking My ineventory I found That I need TO WOrk with the one With Resenator the 20 MHz Crystals had been Finished .

 

So It's Important to Check Your Inventory Before starting your work .

 

 

Board Layout

 

Traces

 

Cutting Edge

Software Needed :

  • Eagle

  • Gimp

  • FabModules

  • AVRDude Assistant

Goals:

Building The Hello ISP44 and Make it ready For Working

I used My Roland Modela (MDX-20) To make this design

 

 

First OpenYour FabModules ANd Load the traces PNG And Make it's Path

After Giving the command send it the tracing screen will Show up

I have been Working on Roland Modela MDX-20

After Milling and Cutting the Circuit it needs to be a little cleaned

then we shoul start to solder the components

 

After Soldering , it's just perfect but we need to upload the firmware to it's Controller

 

i have used "AVR MKII ISP" to upload the Hex file using Avr Dude Assistant