-3D
laser cutting
week, I thought of a 3d puzzle, where units are
fabricated
then the user can apply them
differently I preferred tessellating
over sectioning as it's more creative
yet can give you more than one out put. I
picked this self-growing grid to start with
for the first time.
- First I did the drawing using Auto-CAD
2D, for a single unit the opening
dimension were
made according to the used material thickness 6.5 so i made the opening
a bit smaller to get a tight
joints.
-Then i connected my
laptop to the Epilog
Laser Cutting
machine, and started
printing this grid, on
6.5mm thick cardboard
-I have to
admit my drawings weren't
neat enough, they had
double lines so the
machine cut the same line more than once
which
burnt the cardboard at
some edges. "TIP :
while laser printing if
there's a controllable
fire, leave it, it will
fade out, if not you
have to stop the machine
turn off the fire and
then proceed, to avoid
total loss"
bottom line !
NO DOUBLE LINES
NO HARD FEELINGS
>Proposal
>Digital model
>Laser Cutting
>Electronic
production
>3D Scanning
& Printing
>Electronic Design
>Molding & Casting
>Embedded programing
>Computer-controlled
machining
>Input devices
>Composites