-This week started with an error! since its my very first time designing circuits I USED A WRONG
COMPONENT WHILE DESIGNING i had to realize this while soldering,
 i used the wrong ISP, so i had to repeat all the design over. i also noticed some connections weren't
milled, when i double checked that i found out some connection confusions due-to using the wire system
 in the schematic design.while repeating i used the labeling system in the schematic, it saved time and
it's easier while checking.
The system simply is instead of manually connecting two pins with a wire you just name the pin and
EGALE will logically connect them, so than when it converts to the schematic to a board it will automatically suggest the nearest connection

 
some connections were too tight for the milling machine to mill, i reduces the wire thickness from .16 till .12 and still the milling machine cant read them,
so i had to do a jumper (R0) to help the current jump over the crossing wire
 

Then i had to re-mill the new design. milling and soldering went fine and successfully i had only one not stable connection i knew this while programing
Then i installed ARDUINO 1.0.3, then the ATtiny44, picked the button example changed the pin names according to my boar burned the example then run
the script