NETWORKS
           

               -this week we were to do networks and communications, unlike every week, this week i tried programming my boards with C not arduino IDE,
 I had some problems while milling but then the board were milled and soldered properly.

                                                                                                                                              BRIDGE

                  -Just like any previous board, the bridge board needed an FTDI cable for the power and fab ISP for programming, after connecting everything
 went Fine and the program properly run.

                                                                                                                                              NODE

                 -I made only one node as i was short in time, the node's FTDI cable was connected to the computer while the ISP was connected to the bridge board's 4PIN
 connector  where the program should come from i used same scrip just by changing the node name from 0 (the bridge name) to 1 (the node name)

                -There was an error first time but with rechecking the components connection i managed to run the scrip properly second time after that i connected he
 4 pins of both boards together and the bridge board to the computer through FTDI. with Arduino serial port i typed 1 (the name of the node) so the bridge's LED blinked
 once and the node's LED blinked twice according to the script i downloaded.
                                                                                      WATCH THE BOARD WORK