Electronics Production

Electronics Production :

The first step was milling the board, and for this I used Fab Modules, I load .png en in my case I used an offset value of "6" for the milling with 1/64, and by default for cutting the board with 1/32.

The second step was solder the board, I had cared about the sense of direction of some components: Diode and microcontroller.

The final step was programming, and first I tried to program with AvrStudio-5 and I could not, the message was that my computer not recognized the device (Device Unknown), so I had to use Ubuntu to program and that was the solution, then when I connect the board to the computer, it recognize the device (FabIsp device).

For that reason I show you the steps for programming the FabIsp:

Install Software for AVR Programming :
- sudo apt-get install flex byacc bison gcc libusb-dev avrdude
- sudo apt-get install gcc-avr
- sudo apt-get install avr-libc
- sudo apt-get install libc6-dev
Download and Unzip the Firmware:
- cd ~/Desktop
- wget http://academy.cba.mit.edu/classes/embedded_programming/firmware.zip
- unzip firmware.zip
Programming the FabIsp(Ubuntu):
- make clean
- make hex
- sudo make fuse
- sudo make program